185_vKi-ODM is based on following assembling
Assembled over the pole piece, it reduces the inductance value from 0.33mH to 0.18mH at 1kHz
UP COST = +26€
Assembled below the pole piece, it reduces the inductance modulation
UP COST = +8€
(1) : Bl = 10,2N/A, Mms = +4.2g, Exc lin; = +/-12mm
(2): Bl = 12N/A, Mms = +1.2g, Exc lin; = +/-8mm
(3): Bl = 12N/A, Mms = No change, Exc lin; = +/-8mm
​
(4) : Specific requirements
(1) (2) UP COST = +6€
(4) : MUST BE SPECIFICALLY QUOTED
Adapt the Fs [Hz} to reach expected T&S
Note: With Omega surround Fs cannot be lower than 30Hz.
NO UP COST
Dual spiders are recommended to play largest excursion without any risk of rubbing in any situation (from +/-10mm to +/-15mm).
UP COST : +28€
Omega profile increases the active surface area and allow linear Kms(X) up to +/-10mm.
It is the best choice for those who want to increase the efficiency.
Large roll increases the linear Kms(X) up to +/-15mm, but is reduces the active surface by 14.6cm²
NO UP COST
CGF is 10x more rigid than regular carbon fibres and more damped to reach softer cone break-up. It increases Mms by 1.6g.
UP-COST FOR CGF : 6€
Sale condition:
- Products are neither refund, nor exchanged
- To be paid by bank transfer in the 10 days after invoice reception
- Payment currency : Euro (€)
- Prices are without French VAT (20%)
- Shipment under EXW incoterm
- Packing size, weight and picking address provided at the end of production
- Lead time : 15 - 20days for quantity <50pcs / 30-40days for quantity 50 - 300pcs
- Lead time start after full payment reception
- By sending this request, you confirm accepting to pay related invoice
​
Warranty:
- Products are measured and tested before packing.
- Quality control certificate, including measurements is provided with product.
- Unique identification number is noted on loudspeaker and QC certificate
- Any technical issue will be evaluated by Kartesian company in order to identify the root cause.
- Shipment fees to ship back the products are handled by customer if no assembling issue are identified by Kartesian.
The purpose of ODM is to prototype your _vKi driver to validate its performances are suitable with your requirements before validate and place production order. The price for your production will be discussed after validation.
Thank you for your request - We will answer in a week maximum
