top of page


Crédit photo: .Kartesian company

Sub180_vMS is a long linear excursion transducer, to be used in active compact subwoofer or 3 ways system.

We recommend to use this driver to cover the bandwidth 30 – 700Hz (-3dB).

It has been engineered to provide very accurate cone movements, with +/-11mm linear excursion.

The powerful motor structure is based on advanced pole piece geometry which focus 1.3T in the gap, keeping smooth inductance.

The suspensions use dynamiK and pumaX spiders, mounted with specific vented spacer and low lost rubber surround to avoid any mechanical damping, which could slow down the cone movements.

T&S parameters

Fs : 31Hz

SPL : 85.5dB /2,8V /1m

Re : 6,2Ω

Qms : 2.2%

Qts : 0,33%

Bl : 8.85N/A

VAS : 22.45L

Mms : 25.2g

Sd : 123cm²

Frequency responses

On IEC baffle

Pink noise

Distance: 1m

Signal input: 2,83V

Smoothing: 1/12 octave

Dash curve; 20° & 40° off axe

Curve below 120Hz is simulated:

23L vented enclosure

Tuning frequency: 30Hz

Impedance measured in free air

Sub180_vMS_Rep Fr.png

Mechanical drawing

Unit: mm]

Crédit photo: .Kartesian company

Advanced design

Dynamik Spider.png
Konstant Le(X).png
Kombo magnets.png

Vented paper cone

Low lost NBR surround

Ø37mm Cu voice coil (2 layers)

Optimized pole pieces

Inductance non-linearity device

Innovative pumaX + .dynamiK spiders

Aluminum frame with vented spiders

Advanced measurements

Logo KLIPPEL RGB_transparent.png
Note: We improve continually our products. No contractual data.
bottom of page